Philips DVP3050V/37 - Manual (Page 24)

English
24 Videotape Recording
Read and follow the steps below to record a television program
onto a videotape.
● Before you begin, make sure the DVD/VCR is in VCR mode.
Press VCR so VCR light appears on the front of the DVD/VCR.
1 Turn on the TV and set it to channel 3 or 4 or the
Video In channel. If you connected the DVD/VCR to the
TV using the supplied audio and video cables, select your
TV’s Video In channel. Details are on page 12.
If you connected the DVD/VCR to the TV using the
supplied RF coaxial cable, choose channel 3 (or 4) at the TV.
Details are on pages 9-11.
2 Insert a tape with its record tab intact into the
cassette compartment of the DVD/VCR. If tape
playback begins, press STOP C.
3 Press SPEED until the desired tape speed (SP or
SLP) appears briefly on the screen. Details about tape
speed are on page 60.
4 Press SKIP
∑ ∑/CH K
K or SKIP
w w/CH L
L or the
Number buttons to select the TV channel to
record.
5 Press RECORD I to start recording. “REC” will
appear on the DVD/VCR’s display panel.
6 To pause the recording, press PAUSE k once. “REC”
will flash. To resume recording, press RECORD
I or
press PAUSE k again. “REC” will reappear.
7 To stop recording, press STOP C.
Recording Prevention
Video cassettes have record tabs to ensure that recordings are
not accidentally erased.
1 To prevent recording, break off the tab with a
screwdriver.
2 To allow recording, cover the hole with clear tape.
• Other recording options are on
pages 25-30.
• The VCR will record in a preset
volume.
• Pause will switch to Stop after
5 minutes to protect the VCR
and the tape from damage.
When a recording is paused,
review the pause time remaining
with the
■ marks on the
screen. Each
■ mark equals
1 minute remaining. During the
last minute of paused recording,
the
■ mark will flash.
• If any menu is on the TV screen,
RECORD I on the remote
does not function. Press
CLEAR/RESET to remove the
menu.Then, press RECORD
I .
Or, use RECORD I on the
front of the DVD/VCR.
Helpful Hints
1
Turn on the TV.
2 Insert a tape in the
DVD/VCR.
Remove the
tab to prevent
recording. Cover the
hole to allow
recording.
STANDBY-ON
PLAY
DVD VCR VCR/TV
OK
MENU MENU
DISC/VCR
RETURN TITLE
A-B
CLEAR/RESET SLOW
SUBTITLE ZOOM ANGLE
REPEAT REPEAT AUDIO
SEARCH MODE DISPLAY
SKIP / CH
SYSTEM
PAUSE STOP
MARKER RECORD TIMER SET
SPEED
1 2 3
7 6 5 4
8 9 0 +10
4
5-6
3
7 6
4
H9820UD_IB_EN_1_0210 2/14/05 11:16 AM Page 24