Swi-jack, Programming the swi-jack to work with the vehicle, Step 5 – PAC Automobile Accessories User Manual

Page 3: Version number, Step 6, Step 7, Step 9, Step 10

06-14-07

Step 5.

Refer to

The Vehicle Application Guide. Note the INTERFACE Version Number next to the selected vehicle. Fill in the information

below for quick reference. The Radio Select Switch must be set BEFORE programming the INTERFACE version number. Set the

switch as follows: Alpine = 1, JVC = 2, Kenwood = 3, Clarion = 4 and Blaupunkt = 5

Version Number:

____________

SWI-JACK

Programming the SWI-JACK to Work With the Vehicle

Step 6.

Press and hold programming/

mode button on SWI-JACK. Turn

the vehicle ignition to the ON

position.

The LED on the

SWI-JACK will light.

Step 7.

Release the programming/

mode button.

The LED will turn off,

indicating memory is

cleared.

Step 9.

Press and release the program-

ming/mode button the same

number of times as the desired

version number.

The LED will flash

each time the button is

pressed and released.

After seconds, the

LED will flash the same

amount of times of set

version number.

Step 10.

Turn vehicle ignition

to OFF position.

Vehicle programming

sequence is complete.

SWI-JACK

OFF

ACC

IGN

STRT

OFF

ACC

IGN

STRT

SWI-JACK

(Write Version Number here)

SWI-JACK