Proxima ASA Proxima PROAV9350 - Manual (Page 9)

9
POSITIONING THE PROJECTOR
PREPARATION
Before setting up the projector, install the Projection Lens on the Projector.
1. Before installation, check where the projector is used and prepare suitable lens. For specifications of the
Projection Lens, refer to the manual separately attached or contact the sales dealer where you purchased the
projector.
2. For installation, refer to the installation manual supplied to the Projector.
LENS INSTALLATION
When moving or setting up the projector, be sure to replace the Lens Cover to protect the surface.
And be careful not to hold or subject the lens to strong forces. It may damage the lens, cabinet, or
mechanical parts.
The projection lens can be moved up, down, left and right with the motor-driven lens shift function. This function
makes it easy to provide the projected image where you want.
LENS SHIFT ADJUSTMENT
MOVED UP OR DOWN
MOVED LEFT OR RIGHT
Use the LENS SHIFT button and
the POINT UP/DOWN button to
move the image up or down.
Use the LENS SHIFT button
and the POINT LEFT/RIGHT
button to move the image left
or right.
This projector is designed to project on a flat projection
surface.
ROOM LIGHT
The brightness in the room has a great influence on
the picture quality. It is recommended to limit
ambient lighting in order to provide the best image.
This projector is equipped with cooling fan to protect it from
overheating. Pay attention to the following to ensure proper
ventilation and avoid a possible risk of fire and malfunction.
● Do not cover the vents with papers or other materials.
● Keep the rear grill at least 3 feet (1 m) away from any
object.
● Make sure that there are no objects under the
projector. An object under the projector may prevent
the projector from taking the cooling air through the
bottom vent.
VENTILATION
AIR INTAKE VENT
(BOTTOM SIDE) EXHAUST VENT
(REAR SIDE)
SCREEN