Planet Technology WAP-4030 - Manual (Page 8)

4
Chapter 2 Hardware Installation
Before you proceed with the installation, it is necessary that you have enough information about the
WAP-4030.
2.1 Hardware Connection
12V DC
LAN
RESET ANT
+
1. Locate an optimum location for the WAP-4030. The best place for your WAP-4030 is usually
at the center of your wireless network, with line of sight to all of your mobile stations.
2. Assemble the antennas to WAP-4030. Try to place them to a position that can best cover your
wireless network. The antenna’s position will enhance the receiving sensitivity.
3. Connect RJ-45 cable to WAP-4030. Connect this WAP-4030 to your LAN switch/hub or a single
PC.
4. Plug in power adapter and connect to power source. After power on, WAP-4030 will start to
work.
Note: ONLY use the power adapter supplied with the WAP-4030. Otherwise, the product may be
damaged.
If you want to reset your WAP-4030 to default settings, press the Reset button 5 second.
And then wait for 10 seconds for WAP-4030 restart.