Philips 502-1040510 - Manual (Page 6)

Important 6
1.2 Reducing power consumption
Your HD receiver is designed to reduce its impact on the environment and complies with the
European Directive 2009/125/EC. This is part of Philips’ ongoing commitment to lead the way in
environmental responsibility.
It has a standby mode of operation that needs very little power. See the table below and please note
that:
• When your HD receiver is in the standby mode, you save energy (and therefore money) and
reduce carbon dioxide emissions that damage the environment.
• You use the standby button on your HD receiver or remote control to switch between on and
standby modes. In addition, if your HD receiver is on, but you do not press any button on it or
your remote control for 3 hours (configurable - see ‘Automatic eco mode’ on page 24), your HD
receiver will automatically get into the standby mode.
• You use the ON/OFF switch on the rear panel of your HD receiver to turn off your HD receiver.
• If you are not going to use your HD receiver for several days, you can cut its energy consumption
to zero by unplugging it from the mains wall socket.
• In the off and standby modes, your HD receiver cannot receive updates from the network.
However, at receiver wake-up, you will be prompted by a message if an update notification has
been received.
Mode Front-panel standby
indicator and display
Typical power
consumption (W)
Typical annual
energy use (kWh)
Power
adaptor
unplugged
Not lit up 0 0
Standby Standby indicator is
red
0.86
15
* Active
Standby
Standby indicator is
orange
5.00
On A channel number is
shown on the display
5.80
* Based on your HD receiver being On for 4 hours daily and being in standby for 20 hours .