Tuner settings, The initial setup menu 12 – Pioneer DVR-320-S User Manual

Page 75

The Initial Setup menu

Power Save

• Default setting:

Off

When set to

Off

, signals arriving at the

ANTENNA IN

terminal are passed through to the

ANTENNA OUT

terminal when the recorder is in standby.

You can cut the standby power consumption of the
recorder by turning off the through function for one or
both terminals:

•

– No through function for the antenna terminal

•

Off

– Through function for the antenna terminal

Remote Control Set

• Default setting:

Recorder1

You only need to set this if you are using more than one
Pioneer DVD recorder in the same room.

So that each remote control operates only its own
recorder, make this setting different for each recorder
and remote in the room.

There are three different recorder IDs. When set to

Recorder2

Recorder3

, the remote control mode is

shown in the front panel display.

After selecting a new recorder ID, you have to confirm the
change by selecting

Yes

(use the

(cursor

left/right) buttons), then pressing

ENTER

Note that as soon as you change the recorder ID, the
remote becomes inoperative until you change the remote
to the same ID.

To set the remote, press and hold

RETURN

and a number

button (

) until the indicator on the remote lights.

Setup Navigator

• Default setting:

n/a

The Setup Navigator appears automatically when you
switch on the recorder for the first time (or after resetting
the recorder). It is also available from the Initial Settings
menu should you need it at any other time.

See also

Switching on and setting up

on page 23.

Tuner settings

Auto Channel Setting : Auto Scan

This recorder has a built-in TV tuner for recording PAL B/
G, PAL-1, SECAM D/K and NTSC M/N programs off the
air or from analog cable TV. We recommend that you first
use the Auto Channel Setting described here to tune into
the channels in your area, then if there are any unwanted
channels, you can disable them using Channel Skip
(described below).

Choose ‘Tuner’ from the Initial Setup menu, then

‘Auto Channel Setting’, then ‘Next Screen’.

Select your country then press ENTER to start

tuning.

• You can cancel before auto tuning has finished by

pressing

ENTER

again.