Getting started 04 – Pioneer DVR-320-S User Manual

Page 25

Getting started

Select the TV screen type, ‘Standard (4:3)’ or

‘Wide (16:9)’.

Use the

(cursor up/down) buttons to select, then

press

ENTER

Is your TV compatible with progressive scan

video?

Use the

(cursor up/down) buttons to select

Compatible

Not Compatible

, or

Don’t Know

, then

press

ENTER

• Note that progressive scan video is only output

through the component video outputs and only when
the video source is NTSC (see page 14).

Is this recorder connected to an AV amplifier/

receiver for digital audio?

Use the

(cursor up/down) buttons to select

Connected

, or

Not Connected

, then press

ENTER

• If you select

Not Connected

, that completes the

setup. Press

ENTER

to exit the Setup Navigator, or

select

Go Back

if you want to go back and start again.

• Select the digital audio formats your AV amplifier/

receiver is compatible with.

Use the

(cursor up/down) buttons to select

Dolby

Digital

Dolby Digital, DTS

PCM only

, then press

ENTER

• Check the operating instructions that came with your

AV amplifier/receiver if you’re not sure what it’s
compatible with.

10 Is your AV amplifier/receiver compatible with 96
kHz PCM digital audio?

Use the

(cursor up/down) buttons to select

Compatible

Not Compatible

, or

Don’t Know

, then

press

ENTER

• Check the operating instructions that came with your

AV amplifier/receiver if you’re not sure.

11 Press ENTER to exit the Setup Navigator, or select
‘Go Back’ if you want to start again.

That completes basic setup using the Setup Navigator.

Other settings you can make

After setting up using the Setup Navigator, you should be
ready to start enjoying your DVD recorder. It’s possible,
however, that you may want to make a couple of
additional settings, depending on how the recorder is set
up for TV broadcasts.

• Manual channel setting – This setting lets you skip

channels where there is no station, as well as
manually tune to stations. See

Manual CH Setting

page 76.

• G-Code channel setting – This setting lets you assign

guide channels to ensure that the G-Code
programming system works correctly. See

G-Code

CH Setting

on page 77.

• Setting up the remote to control your TV – You can set

up the supplied remote control to control many
brands of TV. See

Setting up the remote to control your

on page 87.