PYLE Audio PT-690A - Manual (Page 14)

13
REMOTE CONTROL FUNCTION
NO. & NAME DESCRIPTION NO. & NAME DESCRIPTION
1. POWER Push this button to turn the unit into
standby mode, push it again to turn off the
unit. 16. ST/MONO Press this button to alternate between
Stereo and Mono mode when listen
to FM broadcast.
2. MUTE Press this button to mute the sound, push
again to cancel the mute function. 17. VOLUME
UP/DOWN Press these buttons to decrease or increase
the volume.
3. SURROUND
MODE
Press this button to choose one of the
following surround modes: THEATER,
HALL, PASSTHRU, MOVIE, MUSIC
and ROOM. 18. LFE TRIM Under the Pro Logic 5.1CH or DTS 5.1CH
mode, press this button and adjust the
volume to set the Low Frequency output
level
4. DISPLAY Press this button to display the state of
input source.
And when listening to the FM
broadcasting with RDS, press this button
to show PS, PTY, RT and RT. (WITH
RDS) 19. TEST TONE To balance speakers in Dolby Digital or
Dolby Pro Logic mode.
5. PRO LOGIC II When receiving Analog/digital /PCM
signal or 2CH Pro Logic, turn on this
button then the playing is under analog
5.1CH state. 20. INPUT
MODE
To select input modes: ANA, OPT, and
COAX when using digital in.
6. MEMORY Press it to store the broadcast station
as a preset. 21. CH SELECT Select channels by pushing this button.
then use volume key to balance speakers.
7. APS (without
RDS) / PTY
SEARCH (with
RDS) APS---allocates and memorizes radio
stations automatically.
PTY SEARCH---in FM state, press this
button, the current program type appears
on the display, using TUNING +/- to
select the program type you desire. 22. DIMMER Press this key to set the brightness of the
front panel display
8. STEREO With this unit in STEREO mode, only
Front Left & Front Right speakers and
Woofer have output. 23.
SUBWOOFER
ON/OFF Press this button to turn on/off the output
of subwoofer.
9. DOLBY
DIGITAL
Press this button to playback source in
DOLBY DIGITAL or STEREO. 24. INPUT
SELECT Push this button to select inputs Tuner
(FM, AM), VIDEO 1, VIDEO 2, VIDEO
3, DVD, AUX, TAPE and PHONO.
10. STATION +/- Press these buttons to select a preset
channel during the tuner mode. 25. TREBLE Press this button for Treble adjustment,
then press +/- key to adjust the level.
11. DYNAMIC Press this button repeatedly to reach your
desired compression dynamic range. 26. + / - These keys are used for SPK SETUP and
DELAY TIME, Treble and Bass
adjustment.
12. BAND Press this button to alternate between FM
and AM. 27. BASS Press this button for Bass adjustment, then
press +/- key to adjust the level.
13. TUNING - Tuner frequency down. 28. SPK SETUP Under PRO LOGIC II or Digital state, it
can change the desired Speaker Setting
shown on the display.
14. AUTO
MANUAL This button is used to select AUTO or
MANUAL tuning for AM and FM
stations. Press once to set to AUTO
again for MANUAL. 29. DELAY
TIME
Press this button to set the delay time for
the Dolby digital/Dolby Pro Logic modes.
15. TUNING + Tuner frequency up.