Philips WIRELESS PC LINK MICRO MCW770 - Manual (Page 36)

Installing a PC server
See chapter Wireless PC Link “Quick
installation”.
Connecting an additional
appliance
It is possible to use an additional appliance,
e.g.TV,VCR or CD recorder with the unit.
You can choose between high level input
sensitivity (e.g. for a connected TV or VCR)
and low level input sensitivity (e.g. for a
connected CD recorder).
1 Insert the red plug of a cinch cable to the
red socket AUX IN R and the white plug to
the white socket AUX IN L.
2 Connect the other end of the cinch cable
to the audio outputs of the additional
appliance.
3 Press SOURCE on the unit repeatedly until
AUX
is selected.
➜ AUX : the high level input sensitivity for an
additional connected appliance is
selected.
To select the low level input sensitivity press
and hold for more than 2 seconds
SOURCE on the unit until AUX CDR is
selected.
➜ AUX CDR : the low level input sensitivity
for an additional connected appliance is
selected.
To toggle the input sensitivity press
SOURCE again for 2 seconds on the unit.
or
Press AUX on the remote control
repeatedly until the desired input sensitivity
(AUX or AUX CDR) is displayed.
Note: It is not possible to connect a turntable
directly to AUX IN L/R. If you wish to use a
turntable, you have to connect an
RIAA-amplifier to AUX IN L/R on the unit.
Then connect the turntable to the
RIAA-amplifier.
Power
The model and serial numbers are
located on the rear of the unit.
1 Check whether the power voltage as
shown on the type plate corresponds to
your local power voltage. If it does not,
consult your dealer or service organization.
2 Make sure all connections have been
made before switching on the power
supply.
3 Connect the power cable supplied to
AC MAINS ~ and to the wall socket.This
switches on the power supply.
0 0 When the power cable is connected for the
first time to the wall socket TUNER and
AUTO INSTALL - PRESS PLAY
is
displayed. Press either ÉÅ on the unit to
store all available radio stations automatically
(see also chapter “Storing radio stations”) or
if you do not wish to store them now press
Ç on the unit to exit.
When the unit is switched to standby, it is
still consuming some power. To disconnect
the unit from the power completely,
remove the power plug from the wall
socket.
To avoid overheating of the unit a
safety circuit has been built in.
Therefore your unit may disconnect
under extreme conditions. If this
happens, switch the unit off and let it
cool down before reusing it.
Installation
17
English
MC W770/37.1 us eng 8/13/04 17:32 Page 17