Philips SLV3105 User Manual
Page 10
TV2
Note: if it is not the case, press the
ON/OFF switch on the back of the
product.
3.2 Connect receiver
1. Connect the receiver to the second
TV (TV2)
Plug the SCART cable of the receiver
(B) into the SCART port of TV2.
2. Connect the power adapter
a. Take the supplied power
adapter (C) to plug the connector
into the DC 9V power connector
on the Receiver (B).
b. Plug the adapter into the power
outlet.
3. Set the CHANNEL switch to the
same number that on the
transmitter (A).
1. Switch on TV2.
2. Switch on the receiver (B).
3. Select the correct SCART input on
TV2.
4. Point the remote control of the video
source to the receiver (B).
5. Operate the video source with its
remote control.
6. Check if TV2 shows the image of the
video source.
> The receiver is connected correctly.
3.3 Enjoy
All the operations listed on 3.1
and 3.2 should have been done.
Preparation
- Switch on the transmitter (A).
- Switch on the Video source.
- Take these items:
Receiver (B)
Power adapter (C)
Remote control of the video
source.
- Go to TV2.
c. The green LED on the front panel
should be on.
10
Getting started
10 EN