PreSonus FireBox - Manual (Page 21)

4 MIXER
21
FIREBOX Mixer Flowchart:
To set up your Mixer application for zero latency recording (example):
1. Record enable your desired track – turn off input monitoring function (or
mute the track) in your software.
2. Select playback channels of the main output of your audio software in the
SOFTWARE PLAYBACK channel of the FIREBOX mixer. The input on this
channel will be the output of your software.
3. Connect your microphone to input 1 and turn on phantom power if needed.
4. You can now adjust the levels of your microphone and your software
playback to your desired levels for recording (monitoring only).
5. If using headphones select “Mix” under Mix to Phones. – this will send the
output of the Mixer to the headphone output.
6. In the MIXER OUTPUT section of the FIREBOX Mixer, select the pair of
outputs to send out of the FIREBOX (for example studio monitors connected
to outputs 1/2).
6 inputs from the FIREBOX go
directly to mixer and software
Playback from
Software
Mixer Output to one of six
stereo outputs on FIREBOX
Headphone
Out
p
ut can be any pla
y
back stream
from your softwa
re, or th
e mix fro
m
the mixer