Parker Hannifin 192-510011N7 - Manual (Page 14)

HLE – Linear actuators with timing belt drive
Automation
14 Parker Hannifin GmbH
Electromechanical Division
Idler unit
(35)
125 stroke
(35)
Safety
travel
Carriage length 125 L2 L1
10 10
A
A Section A-A
Dimensions in ( ) apply in combination with steel strip cover
Safety
travel
The HLE is also available as
a non-driven, idler unit. In this
case it acts as a guide only.
The profile cross-section and
carriage dimensions corres-
pond to those for the driven
axes.
Please take dimensions L1
and L2 from the following ta-
ble:
HLE80 HLE100 HLE150
Dimensions
Unit
L1 L2 L1 L2 L1 L2
Standard mm 34 34 34 34 46 46
Steel strip cover mm 79 79 79 79 91 91
Carriage with bar (type T or F without load attachment plate)
When ordering an HLE without load attachment plate, the bar is used as a replacement for the belt clamp. The
threads in the carriage are accessible through holes in the bar for mounting your own attachments. Diagrams show
the location of tapped holes for load attachment.
HLE80 / HLE100 standard carriage (T) HLE80 / HLE100 extended carriage (F)
L
2
L
1
L
2
L
Ø9 (3x)
L 2
L
1
L
3
L
L
2
L
3 Ø9 (5x)
HLE Unit L L1 L2 HLE Unit L L1 L2 L3
80 T mm 250 75 50 80 F mm 400 75 75 50
100 T mm 300 95 55 100 F mm 450 95 75 55
HLE150 Standard carriage(T) / extended carriage (F) HLE80 / HLE100 /HLE150
L
2
L 1 L 3
L
L 2 Ø14 (4x)
B
4
12
T
thread.
HLE Unit L L1 L2 L3 HLE Unit B T Thread
150 T mm 350 75 70 60 80 mm 15 20 M8
150 F mm 500 105 100 90 100 mm 25 20 M8
150 mm 30 25 M12