Philips ShowView DVDR612/97 - Manual (Page 13)

11
English
3139 246 13454
Connecting to TV
(cont’d)
The scart or Euro AV cable serves as the
universal connector for picture, sound
and control signals. With this type of
connection, there is practically no loss of
quality in picture or sound transmission.
Have the following cables ready:
1) Antenna cable
2) SCART cable
1
Turn off your TV and remove the antenna
cable from your TV (or Satellite Receiver/
Cable Box). Insert it into the
ANTENNA IN socket at the back of
the DVD recorder.
2
Use the supplied antenna cable to
connect the DVD recorder’s TV OUT
socket to the antenna input socket at the
back of your TV set.
3
Use a SCART cable to connect the DVD
recorder’s EXT 1 (TO TV-I/O) socket
to the SCART socket at the back of your
TV set.
4
Connect the power cable from the DVD
recorder’s ~ MAINS to the power
supply.
5
Press STANDBY-ON 2 on the DVD
recorder to turn it on.
➜
The message '
IS THE TV ON?'
appears on the display panel.
6
Turn on the TV power.
➜
If the connection has properly made,
your TV will automatically turn on to the
Video Input channel for the SCART
socket and you should see the
{ Language and Country } menu
appears on the TV.
➜
If not, select the correct Video In
channel at the TV manually until you see
the { Language and Country } menu.
7
Proceed to page 21 to continue the first
installation.
Helpful Hints:
– If your TV set has several SCART sockets,
select the SCART socket that is suitable for
both video output and video input.
– If your TV set displays a selection menu for
the SCART socket, select 'VCR' as the source
for the SCART socket.
– The EXT 2 AUX-I/O socket is intended
only for additional devices.
AU D IO O U T S-V ID E O IN
V ID E O IN SCART IN
TV
Option 1: Using SCART
socket
1
3 2
4
Antenna or
Satellite/Cable TV signal
1DVDR6xx_Eng00_13454c 9/28/04, 1:25 PM 11