Menu system – PhatNoise KDC-W707 User Manual
Page 32

32
|
English
Menu system
In Standby mode
Security Code
Because authorization by the Security Code is
required when the audio unit is removed from
the vehicle, personalizing this unit by using the
Security Code is helpful in preventing theft.
• Setup Security Code when the Setting> (page 39) is set as OFF. • When you activate the Security Code function, it cannot be released. 1 Enter Standby Press the [SRC] button. 2 Enter Menu mode Press the [MENU] button for at least 1 second. 3 Enter Security Code mode Press the Control knob for at least 1 second. 4 Select the digits to enter Push the Control knob towards [ 4] or [ ¢]. 5 Select the Security Code numbers Push the Control knob towards [FM] or [AM]. 6 Repeat steps 4 and 5, and complete the Security Code. 7 Confirm the Security Code Press the Control knob for at least 3 seconds. 8 Do the step 4 through 7 step operation, and reenter the security code. • If you enter a Code different from your Security Code, you have to start over from step 4. Press the Reset button when the audio unit is 1 Turn the power ON. 2 Do the step 4 through 7 step operation, and reenter the security code. • If an incorrect code is entered, "WAITING" is displayed, and the input prohibition periods shown in the table Number of times the Input prohibited time 1 — 2 5 minutes 3 1 hour 4 24 hours In Standby mode Touch Sensor Tone Setting the operation check sound (beep sound) Display Setting "Beep:ON" Beep is heard. "Beep:OFF" Beep canceled. In Standby mode Manual Clock Adjustment • You can do this adjustment when the Clock> (page 33) is set as OFF. 1 Select Clock Adjustment mode Push the Control knob towards [FM] or [AM]. 2 Enter Clock Adjust mode Press the Control knob for at least 1 second. 3 Adjust the hours Push the Control knob towards [FM] or [AM]. Adjust the minutes Push the Control knob towards [ 4] or [ ¢].
Note, your Security Code is the 4 digit number entered in
your "Car Audio Passport" in this package.
Select the "STANDBY" display.
When "Menu" is displayed, "Security" is displayed.
When "Enter" is displayed, "CODE" is also
displayed.
When "Re-Enter" is displayed, "CODE" is also
displayed.
"Approved" is displayed.
The Security Code function activates.
removed from the battery power source
"Approved" is displayed.
You can begin using the unit.
below is generated.
After the input prohibition time lapses, "CODE" is
displayed, and you can reenter the code.
incorrect code was input
ON/OFF.
Select the "Clock Adjust" display.
The clock display blinks.