Panasonic WJ-HDE510 - Manual (Page 9)

-9-
a WJ-HDE510 with HDD>
The figure shows the WJ-HDE510 with an HDD. The
DVD-RAM is used for backup the data recorded on
the WJ-HD500 Digital Disk Recorder as well as for
storing the data of the extension hard disk drive units
in the system.
1. Connect between the COPY port on the WJ-
HD500 and the COPY IN port on the 1st DVD
Extension Unit with the supplied (WJ-HDE510)
SCSI cable.
Plug the cable end with magnetic core into the
COPY port, and the other ends into the COPY IN
port.
2. Connect between the EXT STORAGE port on the
WJ-HD500 and the EXT IN port on the 1st DVD
Extension Unit with the supplied (WJ-HDE510)
SCSI cable.
Plug the cable end with magnetic core into the
EXT STRAGE port, and the other ends into the
EXT IN port.
Repeat the connection steps for any subsequent
extension units.
The system can be expanded by up to 6
Extension Units. To connect the other Extension
Units, refer to the operating instructions of each
unit for further information.
16
16
15
15
14
14
13
13
12
12
11
11
10
10
9
9
8
8
7
7
6
6
5
5
4
4
3 2
2 3
1
1
SIGNAL GND
SPOT OUT
IN EXT STORAGE COPY
CONTROL ALARM
VIDEO
MODE
DATA REMOTE (WV-CU50) SERIAL
POWER
ON
AC
IN
OFF
IN
OUT
OUT
MULTI SCREEN OUT AUDIO
SCSI ID
TERMINATOR -
+ 1
GND
ON
OFF
SIGNAL
AC IN POWER
EXT IN COPY IN
EXT OUT
G
NC THERMAL ERROROUT
ON
OFF
HDD
INSTALLED
NOT INSTALLED
COPY port
CONTROL port
SIGNAL GND
POWER AC IN
SCSI ID
EXT OUT
EXT IN
TERMINATOR
GND THERMAL ERR
OR OUT
NC
+
– OFF
ON
ON
OFF
Terminal board
SCSI cable
(supplied)
SCSI cable (supplied)
Extension Unit #2
WJ-HDE500/HDE505
SCSI ID=0 to 5
Digital Disk Recorder
WJ-HD500
SCSI ID=6 and 7
COPY
IN
EXT
STORAGE
EXT IN
EXT OUT
EXT IN
SCSI cable
(supplied with
Extension Unit)
DVD Extension Unit #1
WJ-HDE510
SCSI ID=0 to 5
WJ-HD500
CONTROL Port
1 13
14 25
20
7 8 9 10 11 12
DVD Extension Unit #1
Extension Unit #2
Extension Unit #3
Extension Unit #4
Extension Unit #5
Error Out
G
Error Out
G
Error Out
G
Error Out
G
Error Out
G
Extension Unit #6
Error Out
G
Strip
6 mm
To CONTROL port on
the Digital Disk Recorder
WJ-HD500
Terminal board on
the Extension Unit
G THERMAL ERR
OR OUT
NC
Error Output Connection
Connect each of the error outputs to the CONTROL port on the rear panel of the WJ-HD500 as shown below. The WJ-
HD500 will display a thermal error warning on the monitor screen.