Palsonic PDP5010 - Manual (Page 19)

Basic Operations
17
Changing Channels
Using the Channel Buttons (CH+ or CH-)
Press the CH+ or CH- to change channels.
When you press the CH+ or CH-, the unit changes channels in sequence. You will see all the channels
that the unit has memorised.
You will not see channels that were erased.
Direct Accessing Channels
Press the number buttons to go directly to a channel.
To select a one-digit channel: press the 1-9 number buttons to input the channel number and the unit
goes to the selected channel.
To select a two-digit channel: press the button to display - -, press the 0-9 number buttons to input
the channel number and the unit goes to the selected channel.
To select a three-digit channel: press the button to display - - -, press the 0-9 number buttons to
input the channel number and the unit goes to the selected channel.
Note: There are some other methods to select by using the 0-9 number buttons.
When you use the number buttons, you can directly select those channels that were skipped.
Using the Return button
Press this button to switch between the current channel and the previous channel.
Adjusting the Volume
Using the volume buttons (VOL+ and VOL-)
Press the VOL + or VOL- to increase or decrease the volume.
Using the MUTE button
At any time, you can temporarily cut off the sound using the MUTE button. To turn mute off, press the
MUTE button again.