Panasonic KX-F1000AL - Manual (Page 45)

45
8
8. Advanced Operations
Logo print position
To change the setting, proceed as follows.
1 Press (MENU) .
2 Press K , then BA .
3 Press (START/SET) .
4 Press (‹) or (›) to select the desired
setting.
5 Press (START/SET) .
6 Press (MENU) .
MODE=OUT [ ÿŸ ]
LOGO POSITION
SYSTEM SET UP
1 Press (MENU) .
2 Press K , then BC .
3 Press (START/SET) .
4 Press (‹) or (›) to select “ON”.
¡ If this feature is not required, select “OFF”.
5 Press (START/SET) .
6 Press (MENU) .
¡ Then start transmission procedure (see
pages 18 and 19).
MODE=ON [ ÿŸ ]
MODE=OFF [ ÿŸ ]
OVERSEAS MODE
SYSTEM SET UP
Logo, telephone number, date, time and page number will be printed on the transmitted document from your
unit in the following manner.
OUT:
Outside of the transmitted document’s paper size (pre-selected setting)
IN: Inside of the transmitted document’s paper size
OFF: Not printed
You may experience difficulty in transmitting documents overseas.
This feature will make sending documents easier as the transmission speed is slowed down.
Overseas transmission mode
Note:
¡ After the transmission has completed, this feature
will be turned off automatically.
¡ When using this feature, transmission time will
increase.
(MENU)
(‹) / (›) (START/SET) Dial keypad
(MENU)
(‹) / (›) (START/SET) Dial keypad