Bbc1 2. installing your video recorder, Initial installation, Allocating a decoder – Philips VR9185 User Manual
Page 9
Initial installation
a
Open up the battery compartment of your remote control
and place the batteries in it as shown in the picture.
b
Close the battery compartment.
c
Confirm the picture on the TV screen with the
OK
button
on the remote control.
d
If you have connected the aerial to the video recorder,
press the
OK
button. ’Autoinstall’ starts. This picture will
appear on the screen:
AUTOINSTALL
YOUR VIDEORECORDER
IS NOW SEARCHING FOR ALL
AVAILABLE TV CHANNELS
02 TV CHANNELS FOUND
________________________
PLEASE WAIT
Wait until all TV channels have been found. This can take
several minutes.
e
When ’AUTOINSTALL’ is complete, ’AUTOINSTALL
COMPLETE’ will appear on the TV screen.
D If the autoinstall procedure is interrupted, please
read ’Automatic TV channel search (Autoinstall)’ in
the chapter ’INSTALLING YOUR VIDEO RECORDER’
to start autoinstall again.
f
To end, press the
MENU
button.
The initial installation is now complete.
Check the time and date. Please read ’Setting the time
and date’ in this chapter.
D If you have connected a decoder, you must install it
as described in the next section.
D If you have connected a satellite receiver, please
read the section ’satellite receiver’.
Allocating a decoder
Some TV stations will send coded TV channels, that you can
only watch when you use a decoder. You can connect such a
decoder (descrambler) to your video recorder. With the
following function, the connected decoder will automatically
be activated for the TV programme you want to watch.
D With ’Connecting with scart cable and ’Easy
Link/NexTView’ the decoder must be activated for
the TV set.
a
Switch on the TV set. If required, select the programme
number for the video recorder.
b
Choose the television channel on which you wish to use
the decoder with the
;P
or
P =
buttons on the video
recorder or the number buttons
0-9
on the remote
control.
c
Press the
MENU
button on the remote control. The main
menu will appear.
d
Select the line ’INSTALLATION’ with the
P =
or
;P
button and confirm with the
P
button.
e
Select the line ’MANUAL SEARCH’ with the
P =
or
;P
button and confirm with the
P
button.
f
Select the line ’DECODER’ with the
P =
or
;P
button.
INSTALLATION
MANUAL SEARCH
CHANNEL/FREQ.
CH
ENTRY/SEARCH
02
PROGRAMME NUMBER
01
TV CHANNEL NAME
BBC
DECODER
OFF
NICAM
ON
FINE TUNING
+1
________________________________
TO STORE
PRESS
OK
g
Select function ’ON’ with the
Q
or
P
button. When
you select ’OFF’, the function will be switched off.
h
Confirm with the
OK
button.
i
To end, press the
MENU
button.
Your decoder has now been allocated to this TV channel.
D When the function is switched on, ’DEC’ appears in
the display.
BBC1
2.
INSTALLING YOUR VIDEO RECORDER
7