Philips FWD154/98 - Manual (Page 13)

12 EN
4 Get started
Caution
Use of controls or adjustments or performance of •
procedures other than herein may result in hazardous
radiation exposure or other unsafe operation.
Always follow the instructions in this chapter in
sequence.
If you contact Philips, you will be asked for the
model and serial number of this apparatus. The
model number and serial number are on the
back of the apparatus. Write the numbers here:
Model No. __________________________
Serial No. ___________________________
Install remote control
batteries
Caution
Risk of explosion! Keep batteries away from heat, •
sunshine or fi re. Never discard batteries in fi re.
Risk of decreased battery life! Never mix different
•
brands or types of batteries.
Risk of product damage! When the remote control is
•
not used for long periods, remove the batteries.
1
Open the battery compartment.
2
Insert 2 AAA batteries with correct
polarity (+/-) as indicated.
3
Close the battery compartment.
3
1
2
Set the clock
1
In standby mode, press and hold OSD/
DISPLAY on the remote control.
The hour digits are displayed and begin »
to blink.
2
Press VOL +/- on the remote control to
set the hours.
3
Press OSD/DISPLAY .
The minute digits are displayed and »
begin to blink.
4
Press VOL +/- to set the minutes.
5
Press OSD/DISPLAY to confi rm the time.
Tip
During play, you can press and hold • OSD/DISPLAY for
2 seconds to view the clock.
Turn on
1
Press .
The unit switches to the last selected »
source.
Switch to standby
1
Press to switch the unit to standby
mode.
The backlight on the display panel is »
reduced.
The clock (if set) appears on the
»
display panel.
Select the correct source on
TV
1
Turn on the apparatus.
2
Press DISC to select the disc source.
FWD154_98_DFU.indb 章节1:12 FWD154_98_DFU.indb 章节1:12 2009-3-17 11:41:46 2009-3-17 11:41:46