PYLE Audio PT-600A - Manual (Page 4)

CONNECTIONS
Speaker systems
Connect the speaker systems to the SPEAKERS terminals
on the rear panel of the unit with the speaker cords.
When viewed from the front (the listening position), the
speaker mounted on the left should be connected to the L
terminals, and the speaker mounted on the right should be
connected to the R terminals. Be sure to connect the
polarities of the speaker systems and the SPEAKER
terminals correctly (+ to +, - to -). If the polarity of one of
the speaker systems is connected improperly, sound in the
central area between the speakers will appear to be missing,
and the position of the instruments will not be clear,
resulting in a loss of stereo directionality; so take care
when connecting.
* When connecting, do not allow the conductor of the
speaker cords to be exposed from the terminals and come
into contact with other terminals.
Front Left
Front Right
_
L
RIG HT LE FT
_
SPEAKERS6~8 Ω
PHONO
Connect the turntable’s output cord L (white) plug to the L
PHONO terminal and the R (red) plug to the R terminal.
If your turntable is equipped with a grounding cable,
connect it to the unit’s GND terminal. But disconnect it if
you notice increased hum.
PHO NO C D TUNER PL AY RE C
TA PE
PL AY RE C
EQ
L
R
AUDIO
AV 1 AV 2
L
R
Tuner
Connect the TUNER terminals to the OUTPUT terminals
on the tuner using the pin-plug cord.
PHO N O C D TUN ER PL AY R EC
TA PE
PL AY R EC
EQ
L
R
AUDIO
AV 1 AV 2
L
R
OUTPUT