Paradyne Application Module 9109 OCU-DP - Manual (Page 5)

98-15174-01
Front View
(without Bezel)
Power
Supply
5
Removing the Housing’s Bezel
1. Depress the latch at the top of the housing to open the bezel.
2. Lift upward to remove the bezel from the two slots at the bottom of the housing.
496-15123
Save the bezel so it can be reattached once the APM has been installed.
NOTE:
The power supply is visible once the bezel is
removed. It provides low voltage power to the
housing and its cards.
!
WARNING:
If you need to remove the power supply
module, you
must unplug the power cord
from the power receptacle and from the rear
of the housing before attempting to remove
the module.