Proxima ASA MVC-CD1000 - Manual (Page 64)

masterpage:Left
filename[D:\MVC-CD1000 kaihan\3062473121\3062473121MVCCD1000UC\02GB-
MVCCD1000UC\10add.fm]
64
model name1[MVC-CD1000]
[3-062-473-12(1)]
Additional information
Precautions
Do not carry the camera by holding
the disc cover
Do not touch the rotating disc
This may cause serious injuries.
When the pickup lens is dirty and the
camera cannot read any image, clean
the pickup lens using a commercially
available blower.
Cleaning the LCD screen or
viewfinder
Wipe the screen surface with a
cleaning cloth (not supplied) or an
LCD cleaning kit (not supplied) to
remove fingerprints, dust, etc.
Cleaning the camera surface
Clean the camera surface with a soft
cloth slightly moistened with water,
then wipe the surface dry. Do not use
any type of solvent such as thinner,
alcohol or benzene as this may damage
the finish or the casing.
After using your camera at the
seashore or other dusty locations
Clean your camera carefully.
Otherwise, the salty air may corrode
the metal fittings or dust may enter the
inside of your camera, causing a
malfunction.
Your camera is designed for use
between the temperatures of 32 °F to
104 °F (0 °C to 40 °C). Recording in
extremely cold or hot places that
exceed this range is not recommended.
If the camera is brought directly from a
cold to a warm location, or is placed in
a very damp room, moisture may
condense inside or outside the camera.
Should this occur, “DISC ERROR”
appears and the camera will not
operate properly.
Moisture condensation occurs
easily when:
• The camera is brought from a cold
location such as a ski slope into a
warmly heated room.
• The camera is taken from an air-
conditioned room or car interior to
the hot outdoors, etc.
On handling the camera
On pickup lens cleaning
On cleaning
Pickup
lens
On operating temperature
On moisture condensation
01cov.book Page 64 Wednesday, July 19, 2000 10:33 AM