Philips VPZ210AT - Manual (Page 9)

Hookups With a Cable Box (cont’d) 9
IN
OUT
CH3
CH4
ANT OUT
ANT IN
This connection allows you to view any channel. After you connect the VCP, Cable Box, and
TV as shown below, the features on this page will be available.
Watching TV With the VCP Off
1
Use the TV channel selector to set the TV to the Cable
Box output channel (channel 3 or 4).
2
Select the channel you want to watch at the Cable Box.
Playing a Tape
1
Make sure the Cable Box is on the same channel as the
VCP’s CH3/CH4 switch.
2
Use the TV channel selector to put the TV on the Cable
Box output channel (channel 3 or 4).
3
Press the PLAY button to play the tape.
1. Connect a Cable
signal to the VCP’s
ANT(enna) IN Jack.
3. Use a second RF coaxial cable to connect the OUT Jack on
the Cable Box to the ANTENNA IN Jack on the back of the TV.
2. Use an RF coaxial cable (supplied) to connect
the ANT(enna) OUT Jack on the VCP to the IN
Jack on the Cable Box.
TV ANTENNA IN Jack
VPZ210/VPZ215 4/3/99 3:16 PM Page 9