Philips VPZ210AT - Manual (Page 15)

Rear Panel 15
CH3
CH4
ANT OUT
ANT IN
AUDIO
OUTPUT
VIDEO
DC13.2V
ANT(enna) IN Jack
Connect your antenna or cable
here. Details are on pages six-10.
CH3/CH4 Switch
Set to channel 3 or 4 to
use your TV with your
VCP. Details are on pages
six-nine.
ANT(enna) OUT Jack
Use the supplied RF coaxial cable
to connect this jack to the
ANTENNA IN jack on your TV
or Cable Box.
Details are on pages six-nine.
VIDEO OUTPUT Jack
Use a video cable (not supplied) to
connect this jack to the Video In jack
of a TV, camcorder, VCR, or audio-
visual source (laser disc, video disc
player, etc.). Details are on page 10.
AC Power Cord
Connect to a standard AC outlet
to supply power to the VCP.
Make sure the car battery cord is
disconnected from the VCP.
AUDIO OUTPUT Jack
Use an audio cable (not supplied) to
connect this jack to the Audio In
jack of a TV, camcorder, VCR, or
audio source.
Details are on page 10.
DC 13.2V Jack (VPZ215AT only)
Connect the car battery cord here
when you use the VCP in your vehicle.
Details are on page 11. (This jack is not
available on the VPZ210AT.)
VPZ210/VPZ215 4/3/99 3:16 PM Page 15