Philips VPZ210AT - Manual (Page 16)

Before playing a tape, make sure the
VCP and TV are connected (see pages
six-11). Then, follow the steps below.
1
Turn on the TV. Set it to the same
channel as the CH3/CH4 switch on the
back of the VCP.
2
Insert a tape in the VCP. The
power will come on and playback will
start automatically. The POWER light
and the PLAY light will appear on the
display panel of the VCP.
3
If the tape you want to play is already in
the VCP, make sure the VCP power is
on, then press the PLAY button.
4
To stop playback, press the STOP
button on the remote control or the
STOP/EJECT button on the VCP once.
5
Press the REW(ind)/SEARCH but-
ton on the remote control or the
REW(ind) button on the VCP to rewind
the tape.
6
When the tape has finished rewinding,
press the EJECT button on the
remote control once or the
STOP/EJECT button on the VCP again
to eject the tape.
16 Playing
• Other playback options and features are explained on pages 17
and 18.
• Moisture may condense inside the unit when it is moved from a
cold place to a warm place, after heating a cold room, or when
the humidity is high. When moisture has accumulated in your
VCP, the POWER light will blink. (This indication is available on
the VPZ215AT only. On the VPZ210AT, there is no indication
that moisture has accumulated.) If you try to play a tape in a
VCP in which moisture has accumulated, the tape and the VCP
could be damaged. If the POWER light is blinking, keep the VCP
power on (but do not play a tape) for at least two hours. When
the POWER light stops blinking, it is safe to play a tape.
Helpful Hints
3
1
2
4
CH3
CH4 ANT OUT
ANT IN
AUDIO
OUTPUT
VIDEO
DC13.2V
CH 4
or
CH 3
CH3
CH4
CH3 / CH4
Switch
TV and VCP
5
6
POWER EJECT
REW/SEARCH PLAY FF/SEARCH
STOP PAUSE/STILL
TRACKING
Insert a tape in the VCP.
VPZ210/VPZ215 4/3/99 3:16 PM Page 16