Philips LTC 3924 - Manual (Page 6)

5
PHILIPS LTC3924/62 (E) QR34071
CONTROLS AND FUNCTIONS
[FRONT]
1 3 2 4 5 6 7 8
9 1011 12 13 14 1516 DISPLAY (See page 7)
S
1. SLOW TRACKING CONTROL
Adjust to optimize the picture quality in the SLOW
PLAY mode, e.g. speed 40 hours or field advance/
reverse mode.
2. TRACKING CONTROL
Adjust to optimize the picture quality during playback
at the 08, A24 and A40 hour speeds.
3. PROG./SHARPNESS CONTROL
Press to select one of the six programmable func-
tions.
Press to select the picture quality with the UP/HARD
or DOWN/SOFT button to hard or soft during play-
back. See page 22 for SHARPNESS CONTROL.
4. DOWN/SOFT BUTTON
Press to decrement, change or reverse to the
previous/lower value.
Press to adjust the picture quality to soft during play-
back.
5. START/STOP BUTTON
Press to start or stop the programming of a program-
mable function. (Press once to start the programming
sequence and a second time to stop (end) it.)
6. UP/HARD BUTTON
Press to increase, change or advance to the next
higher value.
Press to adjust the picture quality to hard during play-
back.
7. SET BUTTON
Press to select the specific value which is to be
changed with the UP/DOWN buttons.
8. CASSETTE COMPARTMENT
9. COUNTER RESET BUTTON
Press to clear the digital counter to “00000”.
10. RESET BUTTONS
Press these buttons at the same time to clear all
(microprocessor) functions.
Press the “S” button to reset the system. (This does
not erase the stored information.)
11. REC/PLAY HOURS BUTTONS
▲ (UP): Press to increase hours to the next
higher value.
▼ (DOWN): Press to decrease hours to the next
lower value. The tape speed will be
indicated as part of the monitor display.
12. TIMER BUTTON
Press after programming the TIMER for automatic
TIMER recording. See page 15 for TIMER program-
ming.
13. V-POS (VERTICAL POSITION) BUTTON/V. LOCK
BUTTON
Press repeatedly to control the vertical position of the
programmable display on the monitor.
Press to reduce vertical jitter in the still play mode
14. H-POS (HORIZONTAL POSITION) BUTTON/V.
LOCK BUTTON
Press repeatedly to control the horizontal position of
the programmable display on the monitor.
Press to reduce vertical jitter in the still play mode
15. ALARM RESET BUTTON
Press to clear POWER LOSS information. When this
button is pressed the alarm memory is cleared.
16. ALARM INDEX BUTTON
Press this button to cause the INDEX indicator to light,
and set the VCR to the visual search mode (press
F.FWD or REWIND during playback mode) in this
state; the start of the alarm recorded can be located.