Planet Technology SVC2540 - Manual (Page 20)

-17-
4.3 Port Configuration
This function allows displaying each port’s status. The Link Status in the screen displays the current connection speed and
duplex mode; else this function will show down when the port is disconnected. Press the “Refresh” button to renew the
screen. The screen in Figure 4-5 appears.
Figure 4-5 Port Configuration screen
The page includes the following configurable data:
• Port Indicate the Copper port and Fiber port
• Link Displays the current connection speed and duplex mode of Copper or Fiber
• Mode Allow configuring the port speed and operation mode. Draw the menu bar to
select the mode.
• Auto Speed - Setup Auto negotiation.
• 10 half - Force sets 10Mbps/Half-Duplex mode.
• 10 Full - Force sets 10Mbps/Full-Duplex mode.
• 100 half - Force sets 100Mbps/Half-Duplex mode.
• 100 full - Force sets 100Mbps/Full-Duplex mode.
• Disable - Shutdown the port manually.
Default value: Auto Speed
• Flow Control Allow Enable or Disable flow control for selected port.
• Enable – 802.3x flow control is enabled on Full-Duplex mode or
Backpressure is enabled on Half-Duplex mode
• Disable – No flow control or backpressure function on no matter
Full-Duplex or Half-Duplex mode
Default value: Disable
• Ingress Rate Limit The value of inbound traffic limitation in kilobit-per-second (kbps). The possible
values are :
• No Limit
• 512K
• 1M
• 2M
• 4M
• 8M
• 10M
• 50M