Philips MC-M250 - Manual (Page 15)

15
English
3140 115 29261
Tape Operation / Recording
Tape playback
1 Select TAPE source.
➜ The display shows “TAPE TAPE TAPE TAPE TAPE ” briefly.
2 Press OPEN ç to open the tape door.
3 Insert a recorded tape and close the tape door.
● Load the tape with the open side downward and
the full spool to the left.
4 Press ÉÅ to start playback.
To stop playback
● Press Ç.
To reset the tape counter display
● In stop mode, press Ç once.
Rewinding / Fast forwarding
1 Stop playback, press S or T (à or á).
➜ The tape will stop automatically at the end of
rewinding or fast forwarding.
➜ During fast winding, you can monitor the tape
message with the tape counter.
2 Press Ç to stop rewinding or fast forwarding.
Note:
– During rewinding or fast forwarding of a tape, it
is also possible to select another source (CD or
TUNER, for example).
General information on
recording
● For recording, use only NORMAL (IEC type I)
tapes on which the tabs have not yet been
broken. This deck is not suited for recording on
METAL (IEC IV) type tapes.
● The best recording level is set automatically.
Altering the VOLUME, INCREDIBLE
SURROUND or DBB will not affect the
recording in progress.
● At the very beginning and end of the tape, no
recording will take place during the 7 seconds
when the leader tape passes the recorder heads.
● To protect a tape from accidental erasure, have
the tape in front of you and break out the left
tab. Recording on this side is no longer possible.
If, however, you wish to record over this side
again, cover the tabs with a piece of adhesive
tape.
IMPORTANT!
Recording is permissible if copyright or
other rights of third parties are not
infringed upon.
BAND
DISPLAY
MP3•ALBUM VOLUME
PRESET TRACK• SEARCH• TUNE PROGRAM
SOURCE TIMER SET CLOCK
REC
iR
OPEN
S T A N D B Y -O N
-
+
pg 001-020/M250/21-Eng 4/16/02, 7:05 PM 15