Philips MC-M250 - Manual (Page 13)

13
English
3140 115 29261
CD/MP3-CD Operations
Finding a passage within a track
1 Press and hold down on
S or T (à or
á).
➜ The disc is played at high speed and low
volume.
2 When you recognize the passage you want,
release
S or T (à or á).
➜ Normal playback continues.
Note:
– During a disc programme or if REPEAT/
SHUFFLE mode active, searching is only possible
within the same track.
Selecting a desired album/track
(MP3 disc only)
To select a desired album
● Press 4 or 3 repeatedly.
To select a desired track
● Press S or T (¡ or ™) repeatedly.
Different play modes: SHUFFLE
and REPEAT
You can select and change the various play
modes before or during playback.
1 Press MODE on the remote control to select :
➜ shuffle – tracks of the entire disc/
programme are played in random order.
➜ shuffle repeat all
– to repeat the entire
disc/ programme continuously in random order.
➜ repeat all
– to repeat the entire disc/
programme.
➜ repeat
– to repeat the current track.
2 To return to normal playback, press MODE until
the various SHUFFLE/ REPEAT modes are no
longer displayed.
● You can also press 9 to cancel your play mode.
Note:
– If Shuffle is activated on a MP3-CD, all titles
stored in the disc will be played in random order.
Programming the disc tracks
Programming tracks is possible when playback is
stopped. Up to 20 tracks can be stored in the
memory in any order.
1 Press PROGRAM to enter the programming
mode.
➜ A track number is shown and prog flashes.
2 Press
S or T (¡ or ™) repeatedly to
select your desired track number.
● For MP3 disc, press 4 / 3 and S / T
(
¡ or ™) to select the desired album and track
for programming.
3 Press PROGRAM to confirm the track number
to be stored.
➜ The number of tracks programmed and total
playing time of the programme is shown briefly,
then the selected track and “PROG
PROG PROG PROG PROG ”.
➜ For MP3 disc, total playing time will not be
shown.
4 Repeat steps 2-3 to select and store all desired
tracks.
➜ “MEMORY FULL
MEMORY FULL MEMORY FULL MEMORY FULL MEMORY FULL ” is displayed if you attempt
to programme more than 20 tracks.
5 To start playback of your disc programme, press
ÉÅ.
Note:
– It is not possible to create a programme with
MP3 tracks from multiple CDs, or combined with
normal audio tracks.
Reviewing the programme
In stop mode, press and hold PROGRAM until
the display shows all your stored track numbers
in sequence.
Erasing the programme
● Press Ç once when playback is stopped or
twice during playback.
➜ prog disappears and “CLEAR
CLEAR CLEAR CLEAR CLEAR ” is displayed.
Note:
– The programme will be erased when the system
is disconnected from the power supply or when the
disc tray is opened.
pg 001-020/M250/21-Eng 4/16/02, 7:05 PM 13