Pioneer DRM-604X - Manual (Page 11)

Introduction Chapter 1
1-2 Software Driver Installation Guide / Owner’s Manual
***********************************
IBM PC/XT/AT/386 User’s, refer to the
Chapter 3 for installation instructions.
Macintosh User’s, refer to
Chapter 4 for installation instructions.
1) Install a SCSI host adapter (interface card) in the IBM PC or compatible
computer, as per instructions from interface card Manufacturer and in Hardware
Install Owner’s Guide.
NOTE: The Macintosh has a built in SCSI port.
2) With the power turned OFF on both the computer and the CD-ROM
Changer, attach the proper SCSI cable, connecting the two machines.
3) Set the SCSI ID number on the CD-ROM Changer. When it is the only
device attached to an IBM or compatible computer, the factory-set SCSI ID at
0 should work just fine. Otherwise, set the SCSI ID to a number that is not
used by any other device on the SCSI bus. NOTE: The Pioneer Installer for
IBM-PC and compatibles will automatically search the SCSI bus and indicate
the proper SCSI ID number, unless you over-ride this feature. See Chapter 3,
page 3-14 for details. When connecting the Pioneer CD-ROM changer to a
Macintosh, select a SCSI ID number between 1 & 6.
5) Power-ON the computer and back-up the driver diskettes included with the
Pioneer CD-ROM Changer.
4) Power-ON the Pioneer CD-ROM Changer.
6) Launch the Installer program included on the driver diskette. This will
offer you a few simple options, then install the drivers. See Chapters 3 & 4
for details.
8) Reboot your computer. Follow the “Operations Check” for IBM-PC and
compatibles or for Macintosh. If you encounter any difficulties, refer to
Troubleshooting Appendices at the back of this manual.
9) You are ready to use your Pioneer CD-ROM Changer. See page 3-9 for
IBM-PC and compatibles, see pages 4-6 and 4-7 for Macintosh.
Set-Up & Driver Installation Overview