Paxar FreshMarx System Monarch 9416 - Manual (Page 6)

1 -2 Getting Started
C o n n e c t i n g t h e P r i n t e r ’ s P o w e r S u p p l y
To connect the power supply to the printer:
Caution
Do not touch the electrical connectors while
setting up the printer. Electrostatic discharge
can damage or destroy the printhead or
electronic components.
1. Place the printer on a table in a location that
allows easy access to the front of the printer.
Note: Never operate the printer resting on its side
or upside down.
2. Turn off the printer. Press the power switch on
the back of the printer to the off (O) position.
3. Place the power supply in a suitable location,
preferably on a table, near an electrical outlet.
4. Plug the three-hole end of the AC adapter cable
into the three-pronged outlet in the printer’s power
supply.
Caution
The printer’s power supply uses a different
voltage than the keypad. To connect the wrong
power supply could permanently damage the
keypad or the printer.