Surround sound and other settings 05, Setting the channel levels, Sr+ setup for pioneer plasma displays – Pioneer XV-DV535 User Manual
Page 23: English
Surround sound and other settings
05
23
En
English
•
LFE Off
– LFE channel is not played
DTS CD setting
If you play a DTS-encoded CD, you will need to
change this setting to hear the decoded signal.
When
CD Type?
appears, press
ENTER
, then
use
/
to select the setting:
•
NormalCD
– Regular CD playback, DTS-
encoded CDs output a noisy signal
•
DTS-CD
– Proper decoding of DTS-
encoded CDs, but regular CD playback
may lose quality
Setting the channel levels
You can set the relative channel levels from
your main listening position for all of the
listening modes independently.
1
If you have completed
Using the Auto MCACC
setup for optimal surround sound
on page 6,
the channel levels will already be set. You can
still fine-tune the levels here if you need to.
1
Select a listening mode.
Press
SURROUND
or
ADVANCED
repeatedly
to select the listening mode you want.
2
2
Press
TEST TONE
to hear the test tone.
The test tone is output in the following order
(from the speakers active in the current mode):
•
L
– Front left speaker
•
C
– Center speaker
•
R
– Front right speaker
•
RS
– Right surround speaker
•
LS
– Left surround speaker
•
SW
– Subwoofer
3
3
Use the
MASTER VOLUME
+/– button to
adjust the volume to an appropriate level.
Turn down the volume to
40
or less to ensure
you have adequate headroom.
4
Use
/
to adjust the speaker levels in
turn.
You should hear the test tone at the same
volume from each speaker when seated in the
main listening position. The channel level
range is ± 10 dB.
5
When you’re done, press
ENTER
to exit
the test tone setup.
SR+ Setup for Pioneer plasma
displays
Make the following settings if you have
connected a Pioneer plasma display to this
unit using an SR+ cable. Note that the number
of function settings available will depend on
the plasma display you’ve connected.
See also
Using this unit with a Pioneer plasma
display
on page 33.
1
Press SR+ on the remote.
2
When you see ‘Setup?’ appear in the
display, press
ENTER
.
3
Use
/
to select the setting you want.
•
Vol COff
– This unit does not control the
volume of the plasma display
Note
1 • The
SURROUND
modes are divided into two independent groups: multichannel listening modes and stereo modes.
• The speaker volume can be adjusted while listening to any sound source you want by pressing
CH LEVEL
and then using
/
to adjust the channel levels. After finishing a channel, use
/
to move to the next.
2 When the
Auto
listening mode is selected, using the test tone method will adjust levels for multichannel sources only. Use
CH LEVEL
and
/
(see footnote above) to set levels for the
Auto
listening mode with two channel sources.
4
4
DVD MENU
RETURN
MUTE
7
ENTER
MASTER
VOLUME
BASS
MODE
SR+
1
2
3
REPEAT
AUDIO
ANGLE
RANDOM
SUBTITLE
PROGRAM
4
5
6
7
9
MAIN
SUB
ENTER
5
SUB
0
CLR
8
TEST TONE
CH LEVEL
ZOOM
TOP MENU
DIMMER
DISPLAY
ADVANCED
SOUND
DIALOGUE
SURROUND
SETUP
SYSTEM
MIDNIGHT
QUIET/
CLOCK
TIMER/
3 Since the subwoofer produces ultra-low frequencies its sound may seem quieter than it actually is.
XV-DV535_IPPAN.book 23 ページ ２００５年２月２３日 水曜日 午後２時５６分