Panasonic AJ-PD950 - Manual (Page 84)

PARALLEL REMOTE (25P)
Pin No. Signal Pin No. Signal Pin No. Signal
1 PLAY COMMAND 10 19 STAND BY ON STATUS
2 STOP COMMAND 11 20 PREROLL STATUS
3 FF COMMAND 12 10V, MAX 300mA 21 SERVO LOCK STATUS
4 REW COMMAND 13 PLAY STATUS 22
5 REC COMMAND 14 STOP STATUS 23
6 EJECT COMMAND 15 FF STATUS 24
7 STAND BY ON/OFF COMMAND 16 REW STATUS 25 GND
8 PREROLL COMMAND 17 REC STATUS
9 IN SET COMMAND 18 EJECT STATUS
COMMAND pins: TTL level, active low, 100ms edge electrical signal.
STATUS pins: open collector, sink current 6 mA
RS-232C REMOTE (25-pin D-SUB crossover cable supported)
Pin No. Abbreviation
1 FRAME GROUND
2 RxD
3 TxD
4 CTS
5 RTS
6 DTR
7 GND
20 DSR
ENCODER REMOTE (15P)
Pin No. Signal
1
2 SET UP
3 C LEVEL
4 GND
5 +12V
Circuit
Protective ground
Received data
Transmitted data
Clear to send
Request to send
Data terminal ready
Signal ground
Data set ready
Description
Frame ground
Sends data to the PC.
Receives data from the PC.
Shorted with pin 5.
Shorted with pin 4.
No processing
Signal ground
Positive power output after communication
enable status
Pin No. Signal Pin No. Signal
6 SYSTEM H 0 11 RET GND
7 SYS.SC COARSE (2) 12
8 –12V 13
9 HUE 14 SYS.SC FINE
10 VIDEO LEVEL 15 SYS.SC COARSE (1)
- 8 4 -
-
Connector signals
_ >
_ >