beautypg.com

Philips AJ300D User Manual

Page 8

background image

TUNER

1 Press TUNER/AUX once to switch on the radio (FM only).

™ Display shows the radio frequency of the last selected waveband. Your pre-

set station is also shown if you are listening to a preset. (See 2)

2 Adjust the sound using VOL+/-.
3 To select preset stations, press the respective PRESET button (1-5).

TUNING TO RADIO STATIONS
1
Press and hold

¡1 / 2™ until the frequency in the display starts changing.

™Display shows “Scrh” during automatic tuning.
™After the system tunes to a station of sufficient reception, display shows its frequency.

• To tune to a weak station, press

¡1 / 2 ™ briefly and repeatedly until an

optimal reception is found.

To improve reception (FM):
Extend and position the pigtail fully to obtain optimum reception.

STORING AND USING PRESET STATIONS
You can store up to 5 FM radio stations in the memory.
1 Tune to your desired station (see TUNING TO RADIO STATIONS).
2 To store a preset, hold down briefly on a PRESET button 1-5 until you hear a dou-

ble beep.
™ Display shows the preset number of your station.

3 Repeat steps 1 and 2 to store your other stations.
• You can overwrite a preset station by storing another frequency in its place.
4 Press a PRESET button 1-5 (or PRESET 4 / 3 on the remote control) to listen to

a preset station.
™ To display clock time, press

2; on the set.

USING THE ALARM

GENERAL
Two different alarm times can be set. This can be useful when you need to be
woken up at a different time e.g. during the week and at the weekend, and you
can set different wake-up modes:
• tuner mode.
• buzzer mode. The gentle wake buzzer alarm increases its beep tone frequency within seconds.
• dock mode (only for Apple iPod and Philips GoGear SA9100 and SA9200)

IFU_AJ300D_eur_eng 2006.11.9 11:04 Page 8