Resetting the system, Default system settings, Using other functions 08 – Pioneer SC-1525-K User Manual
Page 66

Using other functions
08
66
En
Resetting the system
Use this procedure to reset all the receiver’s settings to
the factory default. Use the front panel controls to do this.
Set MULTI-ZONE to OFF.
• Disconnect the iPod and USB memory device from
the receiver beforehand.
1
Switch the receiver into standby.
2
While holding down ENTER on the front panel,
press
STANDBY/ON.
The display shows RESET
NO .
3
Select ‘RESET’ using PRESET
/, then press
ENTER on the front panel.
The display shows RESET? OK.
4
Press ENTER to confirm.
OK appears in the display to indicate that the receiver
has been reset to the factory default settings.
• Note that all settings will be saved, even if the
receiver is unplugged.
Default system settings
Setting
Default
Digital Video Conversion
ON
SPEAKERS
A
Speaker System
Normal (SB/FH)
Speaker Setting
Front
SMALL
Center
SMALL
FH/FW
SMALL
Surr
SMALL
SB
SMALLx2
SW
YES
Surround Position
IN REAR
Crossover
80 Hz
X-Curve
OFF
THX Audio Setting
4 ft<
DIMMER
Brightest
Network Standby
OFF
Inputs
See Input function default and possible settings on page 41.
HDMI
HDMI Audio
Amp
HDMI output
HDMI OUT ALL
Control
ON
Control Mode
ALL
DIsplay Power Off
YES
DSP
Power On Level
LAST
Volume Limit
OFF
Mute Level
FULL
Phase Control
ON
Sound Retriever
iPod/USB, INTERNET
RADIO, ADAPTER
PORT function
ON
Other functions
OFF
Sound Delay
0.0 frame
Dual Mono
CH1
DRC
AUTO
SACD Gain
0 dB
LFE Attenuate
0 dB
Auto delay
OFF
Digital Safety
OFF
Effect Level
ExtendedStereo
90
Other modes
50
2 PL II Music
Options
Center Width
3
Dimension
0
Panorama
OFF
Neo:6 Options
Center Image
Neo:6 MUSIC: 3
Neo:6 CINEMA: 10
All Inputs
Listening Mode
(2 ch/multi ch)
AUTO
SURROUND
Listening Mode (HP) STEREO
See also Setting the Audio options on page 60 for other default
DSP settings.
MCACC
MCACC Position Memory
M1: MEMORY 1
Channel Level (M1 to M6)
0.0 dB
Speaker Distance (M1 to M6)
10.00 ft
Standing Wave
(M1 to M6)
ATT of all channels/
filters
0.0 dB
SWch Wide Trim
0.0 dB
EQ Data (M1 to M6)
All channels/bands
0.0 dB
EQ Wide Trim
0.0 dB
Setting
Default
SC-1525_UXJCB.book 66 ページ 2010年4月20日 火曜日 午後7時32分