Panasonic KX-TD1232CE - Manual (Page 54)

54
Before Requesting Help Before Requesting Help
P ROBLEM R EMEDY OR S OURCE OF T ROUBLE
The PS does not work.
The PS does not operate.
The PS does not ring.
You cannot dial.
Static, sound cuts in/out, fades.
Interference from other electrical units.
“ CS Busy ” is displayed.
“ PS NO CONNECTED ” is displayed.
You cannot store a phone number and
name in the directory.
The alarm sounds after pressing
(Redial) .
“ ” flashes or beeps tones sound
every 5 seconds during a conversation.
• The battery is empty. Charge the batteries fully (p. 9).
• The PS has been canceled or the PS has not been reg-
istered. To register the PS, refer to system program
[650], “PS Registration”, in the Installation Manual
Addendum for the KX-TD144/KX-TD142/KX-
TD7500.
• The power switch is OFF (❍). Turn it ON (●).
• Ringer volume is set to OFF or VIBRATION.
• The PS is out of range or the Cell Station (CS) is
busy.
• The radio channel is busy or radio communication
error occurs. Try again later.
• The number which you dialed is restricted by the sys-
tem.
• The key lock mode is set. To cancel the mode, see
page 19.
• The radio channel is busy or radio communication
error occurs. Try again later.
• Set the PS and CS away from other electrical appli-
ances.
• Move closer to the CS.
• The Cell Station is busy. Try again later.
• The power switch is set to OFF.
• The PS is out of range.
• The radio channel is busy or radio communication
error occurs. Try again later.
• Your entry exceeds the maximum digits or characters.
• Do not pause for over 30 seconds while programming.
• No number is saved in the Call Log.
• The battery is low. Charge the batteries fully (p. 9).