Pride Mobility Victory XL User Manual

Page 33

Victory XL/RevD/June03

www.pridemobility.com

Figure 18. Frame Locking Levers

LOCKED POSITION

BATTERY WELLS

POSITION FRONT AND REAR SECTIONS

FRONT FRAME HANDLE

Figure 17. Frame Lock

CONNECT FRAME HALVES HERE

Figure 16. Front And Rear Sections

I X . D I S S A S S E M B L Y A N D A S S E M B L Y

ASSEMBLY

1. Pull up on the manual freewheel lever. Putting your

Victory XL in freewheel may make it easier for you

to maneuver the rear section because the drive wheels

are free to turn. See figure 7.

2. Position the front and rear sections of yourVictory

XL as shown in figure 16.

3. Align the lower slots on the rear of the front section

to the corresponding pegs on the front of the rear

section. See figure 17.

4. Gently push the front section of your Victory XL to-

wards the rear section until the curved locking brack-

ets are fully connected onto the rear pegs.

5. Insert the ball detent pin.

6. Place the cam locks in the locked position. See fig-

ure 18.

7. Raise the tiller to the upright position by turning the

tiller adjustment lever until it is loose. Raise the tiller

to the desired position. Verify that the tiller release

buttons are reengaged and the tiller adjustment lever

is tight.

8. Connect the large, white, 9-pin connector (located

on the harness coming out of the Victory XLs front

section) to the connectors mating socket (found near

the front of the Victory XLs rear section). See figure

14.

9. Place the batteries in the battery wells. See figure 18.

10. Connect the 2-pin battery harnesses into the mating

harnesses that extend from the electronic controller

module, then reconnect the battery tie-down straps

(if equipped). See figure 13.

11. Gently place the rear shroud over the seat pedestal

and slide it down into position. The Velcro fasteners

will hold it in place.

12. Carefully lift the seat and slide the seat post (on the

bottom of the seat frame) into the seat pedestal. See

figure 9.

13. Rotate the seat until it locks into place to complete

the assembly of your Victory XL.