Pride Mobility Victory XL - Manual (Page 30)

30
www.pridemobility.com Victory XL/RevD/June03
TILLER ANGLE ADJUSTMENT
You can adjust the tiller to many positions. The tiller adjustment lever locks the tiller in place. It has a spring-loaded
mechanism that enables you to rotate it and change its position.
Figure 8B. Reposition Tiller Adjustment Lever
(Tiller Boot Removed For Clarity)
Figure 8A. Adjusting The Tiller Angle
TILLER ADJUSTMENT
LEVER
RELEASE
BUTTON
TILLER BOOT
PULL OUT TO
REPOSITION
RELEASE
BUTTON
Figure 9. Seat Height Adjustment
LOWER SEAT POST
UPPER SEAT POST
BALL DETEN PIN
LOCATING HOLES
V I I I . C O M F O R T A D J U S T M E N T S
1. Turn the tiller adjustment lever counterclockwise until it
is loose. If the tiller adjustment levercomes in contact
with the tiller basket, pull it outward, turn it clockwise,
and release it. Continue to loosen until the tiller is able
to move. See figures 8A and 8B.
2. Move the tiller to a comfortable position.
3. Turn the tiller adjustment lever clockwise until it is tight.
If the tiller adjustment lever comes in contact with the
tiller basket, pull it outward, turn it counterclockwise, and
release it. Continue to turn the lever until it is tight. The
tiller may be lowered to the center of the floorboard and
locked in place for storage. See IX. “Disassembly and
Assembly.”
SEAT HEIGHT ADJUSTMENT
The seat can be repositioned to one of three different heights.
See figure 9.
1. Remove the seat from your Victory XL. See IX. “Dis-
assembly and Assembly.”
2. Use the attached ring to pull and remove the ball detent
pin from the lower seat post.
3. Raise or lower the upper seat post to the desired seat
height.
4. While holding the upper seat post at that height, match
up the holes in the upper seat post and the lower seat
post.
5. Fully insert the ball detent pin.
6. Replace the seat.
WARNING! Remove the key from the key switch before adjusting the tiller or the seat.
Never attempt to adjust the tiller or the seat while the scooter is in motion.