POLAR S725 User Manual
Page 12
A 10
4. There are two spoke magnet options.
You only need to install one of them.
Check which of the magnets fits the spoke
of your bike best. One (A) is installed by
rotating it around the spoke before putting
the metal cover on, another (B) by
tightening the screw. The magnet must be
facing the speed sensor.
5. Fine-tune the positioning of both the
magnet and the sensor so that the magnet
passes the sensor closely but does not
touch it. The maximum distance between
the speed sensor and the spoke magnet
should be 5 mm/ 0.2". Once positioned
correctly, tighten the cable ties securely
and cut off any excess cable tie ends.
Your safety is important to us. While riding
your bike, please keep your eyes on the
road to prevent possible accidents and
injury. Check that you can turn the handle
bar normally and cable wires for brakes or
gearing do not catch on the sensor. Check
also that the sensor does not disturb
pedaling or the use of brakes or gearing.
5
4
A
B
or