Pioneer AVH-P5900D - Manual (Page 35)

3 Touch c or d to adjust the equalizer
curve.
+6 to
–4 (or –6) is displayed as the equalizer
curve is increased or decreased.
# The actual range of the adjustments are differ-
ent depending on which equalizer curve is se-
lected.
# The equalizer curve with all frequencies set to
0 cannot be adjusted.
Adjusting 7-band graphic equalizer
For CUSTOM1 and CUSTOM2 equalizer
curves, you can adjust the level of each band.
! A separate CUSTOM1 curve can be cre-
ated for each source. If you make adjust-
ments when a curve other than
CUSTOM2
is selected, the equalizer curve settings will
be memorized in
CUSTOM1.
! A CUSTOM2 curve can be created com-
mon to all sources. If you make adjust-
ments when the
CUSTOM2 curve is
selected, the CUSTOM2 curve will be up-
dated.
1 Touch GRAPHIC EQ on the audio func-
tion menu.
2 Touch c or d to select an equalizer
curve.
POWERFUL
—NATURAL—VOCAL—
CUSTOM1
—CUSTOM2—FLAT—
SUPER BASS
3 Touch c or d to select the equalizer
band to adjust.
50Hz
—125Hz—315Hz—800Hz—2kHz—
5kHz —12.5kHz
4 Touch a or b to adjust the level of the
equalizer band.
+12dB to -12dB is displayed as the level is in-
creased or decreased.
# You can then select another band and adjust
the level.
Adjusting loudness
Loudness compensates for deficiencies in the
low- and high-sound ranges at low volume.
1 Touch LOUDNESS on the audio function
menu.
2 Touch d to turn loudness on.
# To turn loudness off, touch c.
3 Touch c or d to select a desired level.
LOW (low)
—MID (mid)—HIGH (high)
Using subwoofer output
This unit is equipped with a subwoofer output
which can be turned on or off.
! When the subwoofer output is on, you can
adjust the cut-off frequency and the output
level of the subwoofer.
1 Touch SUB WOOFER on the audio func-
tion menu.
2 Touch d next to SUB WOOFER to turn
subwoofer output on.
# To turn subwoofer output off, touch c.
3 Touch c or d next to PHASE to select
the phase of subwoofer output.
Touch d to select normal phase and
NORMAL appears in the display. Touch c to
select reverse phase and
REVERSE appears in
the display.
4 Touch c or d next to FREQUENCY to se-
lect cut-off frequency.
Each time you touch c or d selects cut-off fre-
quencies in the following order:
50Hz
—63Hz—80Hz—100Hz—125Hz
Only frequencies lower than those in the se-
lected range are outputted from the subwoo-
fer.
Operating this unit
En
35
Section
03
Operating
this
unit