Pride Mobility 1122 3SP - Manual (Page 20)

20 www.quantumrehab.com Quantum 1122 Series
I I I . Y O U R P O W E R C H A I R
Figure 8. Freewheel Mode (left side shown) Figure 9. Drive Mode (left side shown)
Dual Manual Freewheel Levers
For your convenience, your power chair is equipped with dual manual freewheel levers. The levers are located on the
inside of the anti-tip wheels. The levers allow you to disengage the drive motors and maneuver the chair manually.
WARNING! Do not use the power chair while the drive motors are disengaged! Do not disengage
the drive motors when the power chair is on an incline, as the unit could roll on its own! Only
engage the freewheel mode when on a level surface.
WARNING! It is important to remember that when your power chair is in freewheel mode, the
braking system is disengaged.
To operate the dual manual freewheel levers:
1. Pull up both manual freewheel levers for freewheel mode (drive motor disengaged). See figure 8.
2. Push down both manual freewheel levers for drive mode (drive motor engaged). See figure 9.
If a lever is difficult to move in either direction, rock your power chair back and forth slightly. The lever should then move
to the desired position.
WARNING! Do not use the freewheel lever handles as tie-down points to secure this product.