Panasonic DMP-B15 - Manual (Page 11)

G
e
tt
in
g
st
ar
te
d
RQT9334
(ENG)
11
Preparing the Power
Supply
The unit is in the standby condition (the [ Í] indicator lights)
when the AC power supply cord is connected. The primary
circuit is always “live” as long as the AC adaptor is connected
to an electrical outlet.
≥When connecting the AC adaptor, use the unit after setting it
vertically. Placing the unit with the stand closed
(e.g.:
D 10, 3 in “Installation of the unit”) may cause damage
to or malfunction with the AC adaptor.
To conserve power
This unit consumes 0.5 W (Approximately 5 W when Quick
Start is set to “On”) of power even when turned off. When the
unit is not going to be used for a long time, disconnect the AC
power supply cord from the household AC outlet.
This unit can be used in places without an AC outlet, such as
outdoors, by attaching the included battery pack.
≥The battery is not charged at the time of purchase. Charge
before initial use.
≥The battery is designed only for use with this unit. It cannot be
used with other equipment.
∫Attaching the battery pack
Turn the unit off before attaching or detaching the battery pack.
≥Attach the battery after closing with the LCD screen facing
inwards and the stand open.
∫Detaching the battery pack
When not using for long periods of time
≥Detach the battery pack (D above).
(Even when the unit is turned off, there is a small amount of
voltage running through the unit, and this may result in a
malfunction.)
≥Recharge the battery for re-use.
∫Recharging the battery pack
Attach the battery pack and connect the AC
adaptor (
> left).
≥The [CHARGE] indicator lights while charging the battery, and
the [CHARGE] indicator turns off when battery charging is
finished.
∫Approximate recharging and play times
(Hours)
*1 When the unit is off [at 20 oC (68 oF)]
*2 At room temperature using headphones [at 20 oC (68 oF)]
≥The times indicated on the above may differ depending on use.
≥To change the LCD brightness (> 13, “Adjusting the pictures
on the LCD screen”).
∫Checking the remaining battery charge
When the unit is on ( > 12, “Turning on/off the unit”) and
powered by the battery pack
Press [SUB MENU] to check on the LCD
(displays for a few seconds).
Using the unit connected to the
AC adaptor
Using the battery pack
AC adaptor
(included) To a household
AC outlet AC power supply cord
(included)
1
2 3
RELEASE
DETACH ATTACH
RELEASE
DETACH ATTACH
Bottom side of this unit
Battery pack
(included)
Clicks into place.
Check to make sure it is securely fastened.
2 Slide in to the right.
1 Bring in from the
left, aligning the
grooves.
Recharging* 1
Play* 2
LCD brightness level
j5 0 +5
7 2.5 2.25 2
RELEASE
DETACH ATTACH
Bottom side of this unit
2 Slide.
1 Press and hold.
[CHARGE] indicator
(Yellow light)
(screen)
(flashing) Recharge
Appears automatically when there is only
a few minutes of charge remaining.
DMPB15P-RQT9334_eng.book 11 ページ ２００９年３月２８日 土曜日 午後２時３９分