Show rip peers, Ipsec commands, Add ipsec – Perle Systems IOLAN SDS User Manual
Page 114: Set ipsec, Add ipsec set ipsec
IPsec Commands
114 IOLAN
Reference Guide, Version 3.7
Show RIP Peers
IPsec Commands
Once there is an active VPN tunnel, the IOLAN expects all connections to be established through a
VPN tunnel. To allows hosts to connect outside of the VPN tunnel, you must configure VPN
exceptions, see VPN Exceptions
for the command syntax.
Add IPsec
Set IPsec
Description Shows current information about IPv4 or IPv6 RIP peers.
User Level Normal, Admin
Syntax
show rip peers [ipv6]
Description Adds an IPsec tunnel.
User Level Admin
Syntax
add ipsec <tunnel_name>
Option
<tunnel_name>
The name of an IPsec VPN tunnel. You can configure up to 64 VPN tunnels.
Description Configures the IPsec tunnel.
User Level Admin
Syntax
set ipsec <config_tunnel_name>
[
authentication-method shared-secret|rsa-signature|x.509-certificate
]
[boot-action start|add|ignore] [local-device left|right]
[
local-external-ip-address <IPv4/IPv6_address/FQDN>
]
[local-host-network
<IPv4_addr> <subnet_mask>|
<IPv6_address> <prefix_bits>
]
[local-ip-address <
IPv4/IPv6
_address/FQDN>]
[local-next-hop <
IPv4/IPv6
_address>]
[
remote-external-ip-address <IPv4/IPv6_address/FQDN>
]
[remote-host-network
<IPv4_addr> <subnet_mask>|
<IPv6_address> <prefix_bits>
]
[remote-ip-address <
IPv4/IPv6
_address/FQDN>]
[remote-next-hop <
IPv4/IPv6
_address>]
[remote-validation-criteria
country <code>|state-province <text>|locality <text>
|organisation <text>|organisation-unit <text>
|common-name <text>|email <email_addr>]
set ipsec <config_tunnel_name> secret <text>
set ipsec use-nat-traversal enabled|disabled