Powerware UPS 1000 - 2200 User Manual

Page 12

1000 - 2000 VA

User’s Manual

1019297

Revision A

Battery Mode

When the UPS is operating during a power outage, the alarm beeps once every four
seconds and the

indicator illuminates. When the utility power returns, the UPS

switches to Normal mode operation while the battery recharges.

If battery capacity becomes low while in Battery mode, the

indicator flashes and the

alarm beeps twice every two seconds. Immediately complete and save your work to
prevent data loss and similar difficulties. When utility power is restored after the UPS
shuts down, the UPS automatically restarts.

Sleep Mode

If the UPS is on battery for approximately five minutes and supporting a small electrical
load (

≤

10%), the UPS shuts down the load. After three minutes in Sleep mode, the UPS

initiates a shutdown warning (two beeps every two seconds). This feature conserves
battery power. To enable this feature, contact your service representative.

UPS Configuration

Your PW5125 UPS can be configured by using a configuration software that can be find
on web (www.emea.powerware.com/product/PW5125.htm). This software is a DOS
based program that can be executed from either a DOS box, from a Windows shortcut,
or from the Windows Start, Run dialog box.

UPS setting that can be changed are as follow:

Voltage setting 220/230/240 V (230 V is factory default)

Enable/disable sleep mode (disable as factory default)

Enable/disable audible alarm, so that when disable no audible alarms will be given
(Enable as factory default)

Enable/disable site wiring detection (not supported on European model)

Turning the UPS On

After the UPS is connected to a power outlet, it conducts a self–test and enters Standby
mode. To turn on the UPS, press and hold the On button until you hear the UPS beep
(approximately one second). The

indicator stops flashing and the bar graph

indicators display the percentage of load being applied to the UPS.

Starting the UPS on Battery

NOTE Before using this feature, the UPS must have been powered by utility power at
least once.

To turn on the UPS without using utility power, press and hold the On button for at least
four seconds. The UPS supplies power to your equipment and goes into Battery mode.