Operating instructions, Unpacking and cleaning, Extension cords – Porter-Cable 36-225 User Manual
Page 5: Foreword
5
Use proper extension cords. Make sure your extension cord is in good condition and is a 3-wire extension cord which
has a 3-prong grounding type plug and matching receptacle which will accept the machine’s plug. When using an
extension cord, be sure to use one heavy enough to carry the current of the machine. An undersized cord will cause
a drop in line voltage, resulting in loss of power and overheating. Fig. D, shows the correct gauge to use depending
on the cord length. If in doubt, use the next heavier gauge. The smaller the gauge number, the heavier the cord.
EXTENSION CORDS
Fig. D
MINIMUM GAUGE EXTENSION CORD
RECOMMENDED SIZES FOR USE WITH STATIONARY ELECTRIC MACHINES
Ampere
Total Length
Gauge of
Rating
Volts
of Cord in Feet
Extension Cord
0-6
115
up to 25
18 AWG
0-6
115
25-50
16 AWG
0-6
115
50-100
16 AWG
0-6
115
100-150
14 AWG
6-10
115
up to 25
18 AWG
6-10
115
25-50
16 AWG
6-10
115
50-100
14 AWG
6-10
115
100-150
12 AWG
10-12
115
up to 25
16 AWG
10-12
115
25-50
16 AWG
10-12
115
50-100
14 AWG
10-12
115
100-150
12 AWG
12-16
115
up to 25
14 AWG
12-16
115
25-50
12 AWG
12-16
115
GREATER THAN 50 FEET NOT RECOMMENDED
OPERATING INSTRUCTIONS
FOREWORD
Delta Model 36-225 is a 10" compound miter saw designed to cut wood or aluminum extrusion. Compound angle and
bevel cutting are easy and accurate. It can crosscut up to 5-5/8" x 2-3/4", miter at 45° both left and right 4" x 2-3/4",
bevel at 45° left 1-5/8" x 5-5/8", and compound 45° x 45°, 4" x 1-5/8". It has Patented trigger-controlled indexing with
positive miter stops at 0°, 15.5°, 22.5°, 30°, and 45° both left and right, and bevel stops at 0° and 45° left.
UNPACKING AND CLEANING
Carefully unpack the machine and all loose items from the shipping container(s). Remove the protective coating from
all unpainted surfaces. This coating may be removed with a soft cloth moistened with kerosene (do not use acetone, gaso-
line or lacquer thinner for this purpose). After cleaning, cover the unpainted surfaces with a good quality household floor
paste wax.