Porter-Cable 36-225 - Manual (Page 18)

18
CHANGING THE BLADE
WARNING: USE ONLY CROSS-CUTTING SAW
BLADES. USE ONLY 10" DIAMETER SAW BLADES
RATED FOR 6000 RPM OR HIGHER WITH 5/8"
ARBOR HOLES.
1.
DISCONNECT THE MACHINE FROM THE
POWER SOURCE.
2.
Remove screw (A) Fig. 49.
Fig. 48
CONSTRUCTING WORK SUPPORT EXTENSIONS
One of the unique features of your miter saw is the ease with which you can construct work supports. Fig. 48, illus-
trates the miter saw mounted to two standard 2 x 4’s (A). Fasten the grooves in the four mounting legs, two of which
are shown at (B), to the 2 x 4’s using four screws through the four holes in the mounting legs. The length of the 2 x 4’s
(A) can vary depending on your preference. The distance from the top of the 2 x 4’s (A) to the compound miter saw
table is 3-1/2 inches. This enables you to fasten standard 2 x 4’s (C) to the top of the 2 x 4’s (A), as shown. The top of
the 2 x 4’s (C) will then be the same height as the miter saw table. This method allows you to provide support for long
work-pieces using standard 2 x 4’s instead of constructing an expensive, complicated work support.
MAINTENANCE
C
C
A
B
Fig. 49
A