Philips MX5000/37 - Manual (Page 26)

24
English
Troubleshooting
WARNING
Under no circumstances should you try to repair the system yourself, as this will invalidate the warranty. Do
not open the system as there is a risk of electric shock.
If a fault occurs, first check the points listed below before taking the system for repair. If you are unable to
solve a problem by following these hints, consult your dealer or service center.
Problem Solution
No power. – Check if the AC power cord is properly connected.
No picture. – Select the appropriate video input mode on the TV.
– Check if the TV is switched on.
– Check the video connection.
Distorted or poor picture. – Sometimes a small amount of picture distortion may appear. This is not a malfunction.
– Clean the disc.
The DVD player does not – Insert a readable disc with the playback side facing down.
start playback. – Check the disc type, color system and regional code. Check for any scratches or smudges on
the disc.
– Press SYSTEM MENU to turn off the setup menu screen.
– Cancel the parental control rating function or change the rating level.
– Moisture has condensed inside the system. Remove the disc and leave the system turned on
for about an hour.
The remote control does not – Point the remote control at the remote sensor of the unit.
work properly. – Reduce the distance to the player.
– Remove any possible obstacles.
– Replace the batteries with new ones.
The DVD system does not respond – Disconnect the power plug from the outlet, and insert again.
when the buttons are pressed.
No sound or distorted sound.
– Adjust the volume.
– Check that the speakers are connected correctly.
No image is output when a – Make sure the component is connected correctly.
function is selected. – Press the correct function button for the input source.
Considerable noise in radio – Tune in the correct frequency.
broadcasts. – Connect the antenna.
– Route RF (AC-3) and digital cables away from the antenna terminals and wires.
– Fully extend the FM wire antenna. Position for best reception and secure to a wall.
– Connect an outdoor FM or AM antenna.
– Adjust the direction and position for best reception.
– Turn off the equipment causing the noise or move it away from the DVD system.
– Place the antenna farther away from the equipment causing the noise.
Broadcast station cannot be – The signal is weak. Connect an outdoor antenna.
selected automatically.
The display is dark.
– Press DIM again.
Low hum or buzz sound. – Place the DVD system as far away as possible from electric devices with interference.
Sound is only heard from one – Connect the input cords securely.
channel. – Adjust the channel level.
Sound cuts off or there is no – After turning off the power and then turning it on again, reduce the volume or change to the
sound even though power is on. correct 6-ohm speakers.
Low bass response. – Check all speakers for correct polarity.
No sound from the surround – Set the mode to the desired surround mode position.
speakers. – Use surround mode.
– Check all surround wires for good connection.
No sound from the center – Set surround mode to DTS, DOLBY DIGITAL, or DOLBY PRO LOGIC.
speaker.
The disc tray cannot open.
– Hold down PROGRAM button until “TRAY LOCKED?” appears on the display, then hold down
PLAY button for more than two seconds.
T
ROUBLESHOOTING