Philips 14 PV 202 - Manual (Page 15)

General information
E We suggest that, from now on, you switch off your
TV-Video Combi with the m button on the front of the
set or with the STANDBY m button on the remote control.
When the set is in the standby mode, a small red lamp
(
STANDBY 5 ) at the front of the set will be alight.
E You can switch the machine on with the
;P q ,
=P r or 0..9 buttons or by inserting a cassette.
AAttention: If you use the power switch
8 on the side
panel, you switch off the set completely from the mains
power supply. No programmed recordings are possible in
this state. The red standby lamp (
STANDBY 5 ) at the front
of the set will not be alight. After some time, the date and
clock settings will be lost.
We therefore advise you to keep your TV-Video Combi
connected to the mains and keep the mains switch
8
on at all times to ensure that programmed recordings can
be made and that the television works normally. The
power consumption will be low.
E Attention: If you switch off the appliance using the power
switch 8 , make sure that you have removed the tape
by pressing the ? button.
E If the TV-Video Combi does not receive a signal for more
than 15 minutes, it switches off automatically to conserve
energy.
E If the TV-Video Combi is not plugged into the mains, the
TV channel information is stored for approx. one year and
the clock and timer information will be stored for approx.
30 minutes.
E If a TV channel which transmits Teletext/PDC is stored
under programme number ’P01’ , time and date will
automatically be taken from the Teletext/PDC information
after an interruption of the power supply to the set.
4. IMPORTANT NOTES FOR OPERATION
13