Plantronics WO100 - Manual (Page 7)

Plantronics Savi User Guide 7
2 Base Set Up
2.1 Attaching Charge Cradle to Base
1 Connect the headset charge cradle to the base. Push
firmly on the cradle until the cradle snaps in to place.
2.2 Connecting Base to Desk Phone
1 Connect the telephone interface cable to the telephone
interface cable jack on the base.
2 Disconnect the handset coil cord from the desk phone.
3 Connect the telephone interface cable to the now open
handset port on the desk phone.
4 Connect the handset coil cord to the telephone interface
cable junction box.
5 Place the handset back on the telephone cradle.
2.3 Connecting Power Supply to Base
1 Connect the base power supply into the power jack on
the base.
2 Connect the power supply to outlet. The power indicator
light will be solid green.
2.4 Positioning Base
The minimum recommended separation between your desk
phone and the base is 6 inches.
The minimum recommended separation between the base and
computer is 12 inches. Incorrect position can cause noise and
interference problems.
NOte If your phone has a built-in headset port, you should only
use the headset port if you will not be using the HL10 lifter. In this
configuration, you must press both the headset button on your
phone and the call control button on the headset to answer or
end calls.