Panasonic HDMI SC-HTB15 - Manual (Page 12)

12
VQT3Q59
≥For a safety measure to prevent the speakers from falling, refer to page 16.
≥To prevent damage or scratches, lay down a soft cloth and perform the assembly on it.
Connect the speaker cables.
≥ Insert the wire fully, taking care not to insert beyond the wire insulation.
≥ To make sure that the speaker cable is connected to the correct speaker, match the color of the speaker connector with the
color of the L/R indicator on the speaker label so as not to connect the speaker cable to the wrong speaker.
Drive a screw (not supplied) into the wall.
≥ Use the measurements indicated below to identify the screwing positions on the wall.
≥ Leave at least 20 mm (
25 / 32
q) of space above and each side of the speaker to allow enough space for fitting the speaker.
≥ The position in the wall where the screw is to be attached as well as the screw should be capable of supporting over 33 kg
(72.8 lbs).
≥ Keep the screws out of reach of children to prevent swallowing.
Fit the speaker(s) securely onto the screw(s) with the hole(s).
Place the speakers vertically
∏ 1 Speaker (L) ∏ 1 Speaker (R) ∏ 2 Speaker cables
(L): WHITE
(R): RED
1 Insert the wire fully.
r: White
s: Blue line
2 Press into the groove.
A At least 30 mm (1 3 / 16
q)
B ‰4.0 mm ( 5 / 32
q)
C ‰7.0 mm to ‰9.4 mm
(
9 / 32
q to 3 / 8
q)
D Wall or pillar
E 5.5 mm to 6.5 mm
( 7 / 32
q to 1 / 4
q)
F 55 mm (2 11 / 64
q)
G 24.5 mm ( 31 / 32
q)
DO DO NOT
≥ Move the speaker so
that the screw is in
this position.
≥ In this position, the
speaker will likely fall if
moved to the left or
right.


Push






 
SC-HTB15PP_VQT3Q59_eng.book Page 12 Wednesday, June 8, 2011 3:33 PM